CYLINDER BLOCK REPLACEMENT


  1. REPLACE RING PIN

    Note

    It is not necessary to remove the ring pin unless it is being replaced.


    1. Remove the 12 ring pins.

    2. Using a plastic-faced hammer, install 12 new ring pins.

      A01HXYCE03
      Text in Illustration
      *a Upper Side *b Lower Side
      *c Protrusion Height - -
      Standard Protrusion Height
      Item Specified Condition
      A 5.0 to 7.0 mm (0.197 to 0.276 in.)
      B 4.0 to 7.0 mm (0.157 to 0.276 in.)

  2. REPLACE STRAIGHT PIN

    Note

    It is not necessary to remove the straight pin unless it is being replaced.


    1. Remove the 14 straight pins.

    2. Using a plastic-faced hammer, install 14 new straight pins.

      A01I1VAE03
      Text in Illustration
      *a Front Side *b Rear Side
      *c LH Side *d Lower Side
      *e RH Side *f Protrusion Height
      Standard Protrusion Height
      Item Specified Condition
      A 11.0 to 13.0 mm (0.433 to 0.512 in.)
      B 5.0 to 7.0 mm (0.197 to 0.276 in.)