CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01I1X1

      Lift the rear of the No. 1 engine cover sub-assembly to detach the No. 1 engine cover sub-assembly from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the No. 1 engine cover sub-assembly from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear pins at the same time may cause the No. 1 engine cover sub-assembly to break.

  2. REMOVE CAMSHAFT POSITION SENSOR


    1. Camshaft position sensor (for Exhaust Side)


      1. A01I0BQ

        Disconnect the sensor connector.

      2. Remove the bolt and sensor.

    2. Camshaft position sensor (for Intake Side)


      1. A01HXMY

        Disconnect the sensor connector.

      2. Remove the bolt and sensor.