СИСТЕМА АВТОМАТИЧЕСКОЙ ТРАНСМИССИИ Pattern Select Switch Sport Mode Circuit

DESCRIPTION

The TCM memory contains the programs for the normal and sport shift patterns.

By following the programs corresponding to the signals from the SPORT S/S+ switch (integration control and panel assembly), the park/neutral position switch and other various sensors, the TCM switches the solenoid valves on and off, and controls the transmission gear change operation.

WIRING DIAGRAM

A01X86PE01

PROCEDURE


  1. INSPECT SPORT S/S+ SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)


    1. B001YZQE22
      Text in Illustration
      *a

      Component without harness connected

      (Integration Control and Panel Assembly)

      Remove the integration control and panel assembly Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 (P) - 5 (E) SPORT S/S+ switch on Below 1 Ω
      2 (B) - 5 (E) NORM switch on Below 1 Ω
      3 (P) - 5 (E) SPORT S/S+ switch off 10 kΩ or higher
      2 (B) - 5 (E) NORM switch off 10 kΩ or higher

    NG

    REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL ASSEMBLY - BODY GROUND)


    1. A01X20FE02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Integration Control and Panel Assembly)

      Disconnect the integration control and panel assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      V9-5 (E) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL ASSEMBLY - ECM)


    1. A01WZH0E03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to ECM)

      Disconnect the ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      A38-34 (PWMS) - Body ground SPORT S/S+ switch on Below 1 Ω
      A38-49 (SPCN) - Body ground NORM switch on Below 1 Ω
      A38-34 (PWMS) - Body ground SPORT S/S+ switch off 10 kΩ or higher
      A38-49 (SPCN) - Body ground NORM switch off 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR