| DTC Code | DTC Name |
|---|---|
| P0604 | Random Access Memory (RAM) |
DESCRIPTION
The TCM monitors its internal operation and it will set this DTC when it detects an internal malfunction.
| DTC No. | DTC Detection Condition
|
Trouble Area |
|---|---|---|
| P0604 |
|
TCM |
MONITOR DESCRIPTION
The TCM monitors its internal operation. If the internal operation is malfunctioning, the TCM will illuminate the MIL and store this DTC.
CAUTION / NOTICE / HINT
Note
Perform registration and/or initialization when parts related to the automatic transmission are replaced Click here.
There is a possibility that DTC P0604 is issued from the ECUs of the ECM and TCM. Use the GTS to conduct a health check to confirm which ECU the DTC is issued from and then inspect the related system.
Tech Tips
After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Turn the engine switch on (IG) and wait for 10 minutes or more.
Check for DTCs again Click here.
PROCEDURE
READ OUTPUT DTC (DTC P0604)
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs Click here.
Tech Tips
Write down the currently output DTCs before clearing them.
Turn the engine switch off and turn the GTS off.
Disconnect the GTS.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Read the DTCs using the GTS.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC P0604 is output | B |
| A |
|
CHECK FOR INTERMITTENT PROBLEMS Click here |
| B |
|
REPLACE TCM Click here |