ВЫКЛЮЧАТЕЛЬ ЗАЖИГАНИЯ ПРОВЕРКА

PROCEDURE

1. INSPECT ENGINE SWITCH

   

   Text in Illustration

   *a	Component without harness connected (Engine Switch)

   
   

   1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition 7 (SS1) - 5 (GND) Not pushed 10 kΩ or higher 2 (SS2) - 5 (GND) Not pushed 10 kΩ or higher 7 (SS1) - 5 (GND) Pushed Below 1 Ω 2 (SS2) - 5 (GND) Pushed Below 1 Ω

      If the result is not as specified, replace the engine switch.

   2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

      Tech Tips

      
      

      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

      
      

      • If the voltage is too low, the indicator will not illuminate.

      OK
      Measurement Condition Specified Condition Battery positive (+) → Terminal 11 (SWIL) Battery negative (-) → Terminal 5 (GND) Illuminates (illumination of lettering) Battery positive (+) → Terminal 12 (INDS) Battery negative (-) → Terminal 5 (GND) Illuminates (green) Battery positive (+) → Terminal 13 (INDW) Battery negative (-) → Terminal 5 (GND) Illuminates (amber)

      

      Text in Illustration

      *a

      Component without harness connected (Engine Switch)

      -

      -

      If the result is not as specified, replace the engine switch.