ВЫПУСКНАЯ ТРУБА УСТАНОВКА

PROCEDURE


  1. INSTALL NO. 2 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

    Click here

  2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

    Click here

  3. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. Install a new gasket and the front exhaust pipe to the exhaust manifold RH with 2 new nuts.

      Torque:
      54 N*m  { 551 kgf*cm, 40 ft.*lbf }

    2. Install the wire harness clamp bracket of the oxygen sensor to the transmission with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

    3. Connect the heated oxygen sensor connector.

  4. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY


    1. Install a new gasket and the front No. 2 exhaust pipe to the exhaust manifold LH with 2 new nuts.

      Torque:
      54 N*m  { 551 kgf*cm, 40 ft.*lbf }

    2. Install the wire harness clamp bracket of the oxygen sensor to the transmission with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

    3. Connect the heated oxygen sensor connector.

  5. INSTALL CENTER EXHAUST PIPE ASSEMBLY


    1. Install 2 new gaskets to the front exhaust pipe and front No. 2 exhaust pipe.

    2. Install the center exhaust pipe to the 3 exhaust pipe supports, and then install the 4 bolts.

      Torque:
      48 N*m  { 489 kgf*cm, 35 ft.*lbf }

  6. INSTALL EXHAUST PIPE DAMPER


    1. Install the exhaust pipe damper to the tailpipe with the 2 bolts.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

  7. INSTALL TAILPIPE ASSEMBLY


    1. Install the tailpipe to the 2 exhaust pipe supports.

    2. Install a new gasket to the center exhaust pipe.

    3. Connect the tailpipe to the center exhaust pipe.

    4. B001WRVE02
      Text in Illustration
      *1 Gasket
      *a Top
      *b LH Side
      *c Front

      Attach a new clamp to the tailpipe and center exhaust pipe. Then install the bolt to the clamp.

      Torque:
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }

      Tech Tips

      Install the clamp within the angle range shown in the illustration.

  8. INSPECT FOR EXHAUST GAS LEAK

  9. INSTALL NO. 2 ENGINE UNDER COVER

    Click here