ВПУСКНОЙ КОЛЛЕКТОР СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

    Click here

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  7. DRAIN ENGINE COOLANT

    Click here

  8. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  9. REMOVE AIR CLEANER HOSE ASSEMBLY


    1. B001YTD

      Disconnect the vacuum hose and No. 2 ventilation hose.

    2. Loosen the 2 hose clamps.

    3. Remove the air cleaner hose.

  10. REMOVE INTAKE MANIFOLD


    1. B001VUQ

      Disconnect the ventilation hose from the ventilation pipe of the cylinder head cover LH and RH.

    2. B001WHU

      Disconnect the 2 water by-pass hoses.

    3. Disconnect the throttle body connector.

    4. B001YB7

      Disconnect the No. 1 ventilation hose.

    5. B001WDE

      Disconnect the purge VSV connector.

    6. Disconnect the purge line hose from the purge VSV.

    7. Disconnect the vacuum switching valve connector (for ACIS).

    8. B001WTA

      Remove the No. 1 engine cover sub-assembly.

    9. B001XP5

      Remove the No. 3 engine cover.

    10. B001X01

      Disconnect the 3 wire clamps from the 3 wire brackets.

    11. B001VS3

      Remove the bolt and wire bracket from the intake manifold.

    12. B001WG1

      Remove the 2 nuts, 8 bolts, intake manifold and 2 gaskets.

  11. REMOVE VENTILATION HOSE ASSEMBLY


    1. B001XQO

      Remove the 2 bolts and ventilation hose from the intake manifold.

  12. REMOVE NO. 1 V-BANK COVER BRACKET


    1. B001YX8

      Remove the 2 bolts and bracket.

  13. REMOVE V-BANK COVER BOLT


    1. B001ZOH

      Remove the cover bolt from the intake manifold.

  14. REMOVE NO. 2 V-BANK COVER BRACKET SUB-ASSEMBLY


    1. B001ZIP

      Remove the bolt and bracket.

  15. REMOVE THROTTLE BODY ASSEMBLY


    1. B001WDM

      Remove the 4 bolts, throttle body and gasket.

  16. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)


    1. B001Z3U

      Disconnect the 2 vacuum hoses from the vacuum switching valve.

    2. Remove the bolt and vacuum switching valve.

  17. REMOVE PURGE VSV


    1. B001W9X

      Disconnect the purge line hose from the intake manifold.

    2. Remove the bolt and purge VSV.

  18. REMOVE WIRE HARNESS CLAMP BRACKET


    1. B001WWT

      Remove the 2 bolts and 2 wire harness clamp brackets.