ВЫПУСКНОЙ КОЛЛЕКТОР СНЯТИЕ

PROCEDURE


  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  4. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  5. REMOVE FRONT FENDER APRON SEAL FRONT RH


    1. B001YD2

      Using a clip remover, remove the 3 clips and fender apron seal.

  6. REMOVE FRONT FENDER APRON SEAL REAR RH


    1. B001Z6M

      Using a clip remover, remove the 4 clips and fender apron seal.

  7. REMOVE FRONT FENDER APRON SEAL LH


    1. B001ZFP

      Using a clip remover, remove the 3 clips and fender apron seal.

  8. REMOVE FRONT FENDER APRON SEAL REAR LH


    1. B001WIE

      Using a clip remover, remove the 4 clips and fender apron seal.

  9. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

    Click here

  10. REMOVE TAILPIPE ASSEMBLY

    Click here

  11. REMOVE CENTER EXHAUST PIPE ASSEMBLY

    Click here

  12. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

    Click here

  13. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  14. REMOVE PROPELLER SHAFT HEAT INSULATOR


    1. B001ZXP

      Remove the 2 bolts and heat insulator.

  15. REMOVE NO. 2 MANIFOLD STAY


    1. B001ZQH

      Remove the 3 bolts and No. 2 manifold stay.

  16. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    1. B001WRX

      Remove the 3 bolts and heat insulator.

  17. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH


    1. B001Z6T

      Disconnect the connector and detach the wire harness clamp.

    2. B001VOD

      Remove the 8 nuts, exhaust manifold sub-assembly LH and gasket.

  18. REMOVE NO. 1 MANIFOLD STAY


    1. B001WVB

      Remove the 3 bolts and No. 1 manifold stay.

  19. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. B001WJN

      Remove the 3 bolts and heat insulator.

  20. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH


    1. B001VL0

      Disconnect the connector and detach the wire harness clamp.

    2. B001VQ5

      Remove the 8 nuts, exhaust manifold sub-assembly RH and gasket.

  21. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

    Click here

  22. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

    Click here