ЭЛЕКТРОВАКУУМНЫЙ КЛАПАН (для ACIS) ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)


    1. Disconnect the vacuum switching valve connector.

    2. B001ZANE11
      Text in Illustration
      *a Body Ground

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 37 to 44 Ω
      1 - Body ground Always 1 MΩ or higher
      2 - Body ground

      If the result is not as specified, replace the vacuum switching valve assembly.

    3. B001XQZE03
      Text in Illustration
      *1 Filter
      *a Vacuum

      When applying vacuum to port E, check that air is sucked into the filter.

      If the result is not as specified, replace the vacuum switching valve assembly.

    4. B001ZG7E08
      Text in Illustration
      *a Vacuum

      Apply battery voltage to the connector, and check the VSV operation.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 1

      Battery negative (-) → Terminal 2

      		 Air is sucked into port E when a vacuum is applied to port F

      If the result is not as specified, replace the vacuum switching valve assembly.

    5. Connect the vacuum switching valve connector.

  3. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here