ДАТЧИК УРОВНЯ ТОПЛИВА В СБОРЕ (для расширительного топливного бачка) УСТАНОВКА

PROCEDURE


  1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. Install a new gasket to the fuel sender gauge assembly.

    2. Install the fuel sender gauge assembly with the 5 screws.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

      Note

      Be careful not to bend the arm of the fuel sender gauge assembly.

    3. Connect the fuel sender gauge connector.

  2. INSTALL REAR FLOOR SERVICE HOLE COVER


    1. Install the rear floor service hole cover with new butyl tape.

  3. INSTALL REAR NO. 7 AIR DUCT


    1. B001YTEE01

      Attach the 4 clips to install the rear No. 7air duct.

      Tech Tips

      Attach the clips in the order shown in the illustration.

  4. INSTALL REAR FLOOR MAT ASSEMBLY


    1. Attach the 5 clips to install the rear floor mat assembly.

  5. INSTALL REAR NO. 2 SEAT ASSEMBLY


  6. INSTALL REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

    Click here

  7. INSTALL REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

    Click here

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.