ДАТЧИК УРОВНЯ ТОПЛИВА В СБОРЕ (для расширительного топливного бачка) СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

    Click here

  4. REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

    Click here

  5. REMOVE REAR NO. 2 SEAT ASSEMBLY


  6. REMOVE REAR FLOOR MAT ASSEMBLY

    B001Z98

    1. Detach the 5 clips and fold back the rear floor mat assembly toward the front of the vehicle.

      Tech Tips

      Fold back the rear floor mat assembly so that the rear No. 7 air duct can be removed.

  7. REMOVE REAR NO. 7 AIR DUCT


    1. B001YZ0

      Detach the 4 clips and remove the rear No. 7 air duct.

  8. REMOVE REAR FLOOR SERVICE HOLE COVER

    B001ZRS

  9. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. B001W6A

      Disconnect the fuel sender gauge connector.

    2. B001WK8

      Remove the 5 screws and fuel sender gauge assembly.

      Note

      Be careful not to bend the arm of the fuel sender gauge assembly.

    3. Remove the gasket from the fuel sender gauge assembly.