ТОПЛИВНЫЙ НАСОС РАЗБОРКА

CAUTION / NOTICE / HINT

Note:

Do not disconnect the hoses indicated in the illustration.

PROCEDURE

1. Click here

   REMOVE FUEL SENDER GAUGE ASSEMBLY

   Click here

2. Click here

   REMOVE NO. 1 FUEL SUB-TANK

   
   
   1. 

      Disconnect the fuel pump connector.

   2. 

      Disconnect the jet pump (labeled A) from the sub-tank.

   3. Disconnect the jet pump (labeled B) from the sub-tank.

      Table 1. Text in Illustration

      *1

      Jet Pump

      
      

      1. Using a small screwdriver, detach the claw from the sub-tank.

         Tip:

         Tape the screwdriver tip before use.

   4. 

      Using a screwdriver, detach the 3 claws from the claw holes.

      Note:

      Do not damage the fuel sub-tank.

      Tip:

      Tape the screwdriver tip before use.

   5. 

      Using a screwdriver, detach the 3 claws from the claw holes.

      Note:

      Do not damage the fuel sub-tank.

      Tip:

      Tape the screwdriver tip before use.

3. Click here

   REMOVE FUEL PUMP

   
   
   1. 

      Using a screwdriver, detach the 5 claws from the claw holes and disconnect the fuel pump from the fuel filter case.

      Table 2. Text in Illustration

      *1	Fuel Filter Case

      Tip:

      Tape the screwdriver tip before use.

   2. 

      Disconnect the fuel pump wire harness connector from the fuel pump to remove it.

   3. 

      Remove the O-ring and spacer from the fuel pump.

      Table 3. Text in Illustration

      *1	O-Ring
      *2	Spacer

4. Click here

   REMOVE FUEL MAIN VALVE ASSEMBLY

   
   
   1. 

      Remove the fuel main valve from the fuel filter case.

   2. Remove the 2 O-rings from the fuel main valve.

      Table 4. Text in Illustration

      *1	Fuel Filter Case
      *2	O-Ring

5. Click here

   REMOVE NO. 1 FUEL SUCTION SUPPORT

   
   
   1. 

      Detach the 2 claws from the claw holes to remove the fuel suction support.