ПОДОГРЕВАЕМЫЙ КИСЛОРОДНЫЙ ДАТЧИК УСТАНОВКА

PROCEDURE

1. Click here

   INSTALL NO. 2 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

   
   
   1. 

      Temporarily install the sensor to the exhaust pipe by hand.

   2. 

      Using SST, tighten the sensor.

      09224-00010

      without SST
      44 N*m	449 kgf*cm	32 ft.*lbf
      with SST
      40 N*m	408 kgf*cm	30 ft.*lbf

      Table 1. Text in Illustration

      *1	Fulcrum Length

      Tip:
      

      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).

      • Make sure SST and the wrench are connected in a straight line.

2. Click here

   INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

   
   

   1. Temporarily install the sensor to the exhaust pipe by hand.

   2. 

      Using SST, tighten the sensor.

      09224-00010

      without SST
      44 N*m	449 kgf*cm	32 ft.*lbf
      with SST
      40 N*m	408 kgf*cm	30 ft.*lbf

      Table 2. Text in Illustration

      *1	Fulcrum Length

      Tip:
      

      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).

      • Make sure SST and the wrench are connected in a straight line.

3. Click here

   INSTALL FRONT EXHAUST PIPE ASSEMBLY

   Click here

4. Click here

   INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY

   Click here

5. Click here

   INSPECT FOR EXHAUST GAS LEAK

   Click here

6. Click here

   INSTALL NO. 2 ENGINE UNDER COVER

   Click here