ДАТЧИК ТЕМПЕРАТУРЫ ОХЛАЖДАЮЩЕЙ ЖИДКОСТИ УСТАНОВКА

PROCEDURE

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

   
   

   1. Install a new gasket to the sensor.

   2. Using a 19 mm deep socked wrench, install the sensor.

      Torque:

      20 N*m  { 200 kgf*cm, 14 ft.*lbf }

   3. Connect the sensor connector.

2. ADD ENGINE COOLANT

   Click here

3. INSPECT FOR COOLANT LEAK

   Click here

4. INSTALL V-BANK COVER SUB-ASSEMBLY

   Click here

5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

   Click here

6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

   Click here

7. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

   Click here