КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ УСТАНОВКА

PROCEDURE


  1. INSTALL THROTTLE BODY ASSEMBLY


    1. Install the 2 water by-pass hoses to the throttle body.

    2. B001W54E06
      Text in Illustration
      *1 Groove
      *2 Protrusion
      *a Surge Tank Side
      *b Throttle Body Side

      Install a new gasket to the intake air surge tank.

      Tech Tips

      Align the protrusion of the gasket with the groove of the intake air surge tank.

    3. Install the throttle body with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    4. Connect the throttle position sensor and control motor connector.

    5. Connect the 2 water by-pass hoses.

  2. ADD ENGINE COOLANT

    Click here

  3. INSTALL AIR CLEANER HOSE ASSEMBLY

    Click here

  4. INSPECT FOR COOLANT LEAK

    Click here

  5. CHECK THROTTLE BODY ASSEMBLY

    Click here

  6. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  7. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  8. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  9. PERFORM INITIALIZATION

    Note

    Perform the following procedure after replacing the ECM, throttle body assembly or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.


    1. Disconnect the cable from the negative (-) battery terminal. Wait at least 60 seconds and reconnect the cable.

    2. Turn the engine switch on (IG) without operating the accelerator pedal.

      Note

      If the accelerator pedal is operated, perform the above steps again.

    3. Connect the intelligent tester to the DLC3 and clear the DTCs Click here.

    4. Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

      Standard
      Condition Engine Idle Speed
      A/C switched off 650 to 750 rpm

      Note


      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in N or P.

    5. Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Volt %. Fully depress the accelerator pedal and check that the value is 60% or more.

    6. Perform a road test and confirm that there are no abnormalities.

  10. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here