BACK DOOR GARNISH(w/ Tire Carrier) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • A bolt without a torque specification is shown in the standard bolt chart Click here.

  • When installing the back door garnish, heat the vehicle body and back door garnish using a heat light.

    Standard Heating Temperature
    Item Temperature
    Back Door Garnish 20 to 30°C (68 to 86°F)
    Vehicle Body 40 to 60°C (104 to 140°F)

    Note

    Do not heat the back door garnish and vehicle body excessively.

PROCEDURE


  1. INSTALL REAR LICENSE LIGHT COVER

    Click here

  2. INSTALL LICENSE PLATE LIGHT ASSEMBLY

    Click here

  3. INSTALL NO. 2 BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE


    1. Pass the wire harness of the license plate light through the tail gate, and install the wire harness.

    2. Attach the 7 clips to install the No. 2 back door garnish.

      A01WYYS
    3. B001VNS

      Install the 2 nuts and connect the connector.

  4. INSTALL BACK DOOR TRIM PANEL ASSEMBLY

    Click here

  5. INSTALL BACK DOOR TRIM COVER RH

    Click here

  6. INSTALL BACK DOOR TRIM COVER LH

    Click here

  7. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  8. INSTALL SYMBOL EMBLEM

    Click here

  9. INSTALL BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE RH


    1. Clean the vehicle body surface.


      1. Using a heat light, heat the vehicle body surface.

      2. Remove the double-sided tape from the vehicle body surface.

      3. Wipe off any tape adhesive residue with cleaner.

    2. Install a new back door garnish.


      1. Using a heat light, heat a back door garnish and the vehicle body surface.

      2. Remove the peeling paper from the face of the back door garnish.

        Tech Tips

        After removing the peeling paper, keep the exposed adhesive free from foreign matter.

      3. Attach the 7 clips and double-sided tape to install the back door garnish.

        Tech Tips

        Press the back door garnish firmly to install them.

        A01X5EFE04
        *1 Double-sided Tape