BACK DOOR GARNISH(w/ Tire Carrier) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

When removing the back door garnish, heat the back door garnish and vehicle body using a heat light.

Standard Heating Temperature
Item Temperature
Back Door Garnish 20 to 30°C (68 to 86°F)
Vehicle Body 40 to 60°C (104 to 140°F)

Note

Do not heat the back door garnish and vehicle body excessively.

PROCEDURE


  1. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE RH


    1. Put protective tape around the back door garnish.

    2. Detach the 7 clips and remove the double-sided tape to remove the back door garnish.

      A01X5EFE03
      *1 Protective Tape
      *2 Double-sided Tape

  2. REMOVE SYMBOL EMBLEM

    Click here

  3. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  4. REMOVE BACK DOOR TRIM COVER LH

    Click here

  5. REMOVE BACK DOOR TRIM COVER RH

    Click here

  6. REMOVE BACK DOOR TRIM PANEL ASSEMBLY

    Click here

  7. REMOVE NO. 2 BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE

    B001VNS

    1. Remove the 2 nuts and disconnect the connector.

    2. Put protective tape around the No. 2 back door garnish.

    3. Detach the 8 clips.

    4. Pull out the wire harness of the license plate light from the tail gate, and remove the No. 2 back door garnish.

      A01WYYSE01
      *1 Protective Tape

  8. REMOVE LICENSE PLATE LIGHT ASSEMBLY

    Click here

  9. REMOVE REAR LICENSE LIGHT COVER

    Click here