REAR DOOR WINDOW FRAME MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.

Standard Heating Temperature

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)
Window Frame Moulding	20 to 30°C (68 to 86°F)

Note

Do not heat the vehicle body and window frame moulding excessively.

PROCEDURE

INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING LH
1. Clean the vehicle body surface.
  1. Using a heat light, heat the vehicle body surface.
  2. Remove the double-sided tape from the vehicle body surface.
  3. Wipe off any tape adhesive residue with cleaner.
2. Install a new window frame moulding.
  1. Using a heat light, heat a new window frame moulding and the vehicle body surface.
  2. Remove the peeling paper from the face of the window frame moulding.
    
    Tech Tips
    
    After removing the peeling paper, keep the exposed adhesive free from foreign matter.
  3. *1 Double-sided Tape
    
    Attach the clip and double-sided tape to install the window frame moulding.
    
    Tech Tips
    
    Press the window frame moulding firmly to install it.
INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

Click here
INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Click here
INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Click here
INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

Click here
INSTALL REAR DOOR GLASS RUN LH

Click here
INSTALL REAR DOOR SERVICE HOLE COVER LH

Click here
INSTALL REAR INNER DOOR GLASS WEATHERSTRIP LH

Click here
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here
INSTALL ASSIST GRIP COVER LH

Click here
INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

Click here
INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

Click here
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.