FRONT DOOR WINDOW FRAME MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.

Standard Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)

Note

Do not heat the vehicle body and window frame moulding excessively.

PROCEDURE


  1. INSTALL FRONT DOOR REAR WINDOW FRAME MOULDING LH


    1. Clean the vehicle body surface.


      1. Using a heat light, heat the vehicle body surface.

      2. Remove the double-sided tape from the vehicle body surface.

      3. Wipe off any tape adhesive residue with cleaner.

    2. Install a new window frame moulding.


      1. Using a heat light, heat a new window frame moulding and the vehicle body surface.

      2. Remove the peeling paper from the face of the window frame moulding.

        Tech Tips

        After removing the peeling paper, keep the exposed adhesive free from foreign matter.

      3. B001ZLKE07
        *1 Double-sided Tape

        Attach the clip and double-sided tape to install the window frame moulding.

        Tech Tips

        Press the window frame moulding firmly to install it.

  2. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR GLASS RUN LH

    Click here

  4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  5. INSTALL FRONT INNER DOOR GLASS WEATHERSTRIP LH

    Click here

  6. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  7. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

    Click here

  8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  10. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH

    Click here

  11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

    Click here

  12. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH

    Click here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.