REAR BUMPER(w/ Pintle Hook) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR


    1. Install the No. 2 luggage compartment side cover protector with 2 new grommets.

    2. Install the 2 screws.

  2. INSTALL NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

    Tech Tips

    Use the same procedure described for the LH side.

  3. INSTALL REAR BUMPER ARM BRACKET LH


    1. Install the rear bumper arm bracket LH with the 2 bolts.

    2. Connect the connector.

  4. INSTALL REAR BUMPER ARM BRACKET


    1. Install the rear bumper arm bracket with the bolt.

      Tech Tips

      Use the same procedure to install the rear bumper arm bracket on the other side.

  5. INSTALL REAR NO. 2 BUMPER REINFORCEMENT


    1. Install the rear No. 2 bumper reinforcement with the 2 bolts.

  6. INSTALL REAR BUMPER SIDE SUPPORT LH


    1. Attach the 6 claws to install the rear bumper side support LH.

    2. Install the 3 screws.

  7. INSTALL REAR BUMPER SIDE SUPPORT RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. INSTALL REAR UPPER BUMPER RETAINER LH


    1. Attach the 2 clips to install the rear upper bumper retainer LH.

  9. INSTALL REAR UPPER BUMPER RETAINER RH

    Tech Tips

    Use the same procedure described for the LH side.

  10. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

    Click here

  11. INSTALL REAR COMBINATION LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  12. INSTALL REAR BUMPER COVER

    Tech Tips

    For the rear bumper cover with tire carrier, use the procedures described below.


    1. w/ TOYOTA Parking Assist-sensor System or w/ Rear Fog Light:

      Connect the No. 2 frame wire connector.

    2. Attach the 14 claws to install the rear bumper cover.

    3. Install the 7 bolts, 6 screws and 2 clips.

    4. Open the tail gate and install the 4 clips.

    5. Close the tail gate.

  13. INSTALL REAR NO. 1 BUMPER PLATE


    1. Attach the 20 claws to install the rear No. 1 bumper plate.

  14. INSTALL REAR QUARTER PANEL MUDGUARD LH

    Click here

  15. INSTALL REAR QUARTER PANEL MUDGUARD RH

    Click here

  16. INSTALL SPARE WHEEL CARRIER SUB-ASSEMBLY (w/ Tire Carrier)

    Click here

  17. INSTALL SPARE WHEEL COVER SUB-ASSEMBLY (w/ Tire Carrier)

    Click here

  18. INSTALL SPARE WHEEL CARRIER HINGE BRACKET (w/ Tire Carrier)

    Click here

  19. INSTALL PINTLE HOOK ASSEMBLY


    1. Install the pintle hook assembly and pintle hook bracket with the 2 bolts, 2 eyelet pintle hooks and 4 nuts.

      Torque:
      for nut
      65 N*m  { 663 kgf*cm, 48 ft.*lbf }

    2. For vehicles with a spare installed to the underbody, install the spare tire.