FRONT BUMPER(w/ Winch) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for HID Headlight)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A01X7C1

      Remove the 3 bolts and screw.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. A01X5QK

      Remove the 3 bolts and 2 screws.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.

  5. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  6. REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY


    1. A01X91U

      Detach the 2 claws.

    2. Detach the 3 guides and remove front bumper winch cover sub-assembly.

  7. REMOVE RADIATOR GRILLE ASSEMBLY

    Click here

  8. REMOVE FRONT BUMPER COVER


    1. Put protective tape around the bumper cover.

      A01XAYAE01
      Text in Illustration
      *1 Protective Tape - -

    2. Using a T30 "TORX" socket, remove the 6 screws.

      A01X6S7E01
      Text in Illustration
      *A LH Side *B RH Side

    3. Remove the 3 clips, 4 screws and 4 bolts.

    4. Detach the 10 claws.

      A01XAEX

    5. Disconnect the winch control wire connector and remove the front bumper cover.

    6. w/ Fog Light:

      Disconnect the No. 4 engine room wire connector and remove the front bumper cover.

  9. REMOVE FRONT BUMPER EXTENSION LH


    1. A01XA3T

      Remove the 3 bolts and front bumper extension LH.

  10. REMOVE FRONT BUMPER EXTENSION RH

    Tech Tips

    Use the same procedure described for the LH side.

  11. REMOVE FRONT BUMPER SIDE SUPPORT LH


    1. A01X8F5

      Remove the 2 screws.

    2. Detach the 3 clips and remove the front bumper side support LH.

  12. REMOVE FRONT BUMPER SIDE SUPPORT RH

    Tech Tips

    Use the same procedure described for the LH side.

  13. REMOVE HEADLIGHT ASSEMBLY LH


    1. for Halogen Headlight:

      Click here

    2. for HID Headlight:

      Click here

  14. REMOVE HEADLIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  15. REMOVE FRONT UPPER CENTER BUMPER RETAINER


    1. A01WYY5

      Remove the 3 bolts and front upper center bumper retainer.