HAZARD WARNING SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY (w/o Audio)


    1. Attach the 2 claws to install the hazard warning switch assembly to the center No. 1 instrument cluster finish panel.

  2. INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Audio)

    Click here

  3. INSTALL CLOCK ASSEMBLY (for Radio and Display Type (Hazard Warning Switch))


    1. Install the clock assembly with the 2 screws.

  4. INSTALL RADIO RECEIVER ASSEMBLY (for Radio and Display Type)

    Click here

  5. INSTALL MULTI-DISPLAY ASSEMBLY (w/ Navigation System (Hazard Warning Switch))


    1. Connect each connector.

    2. B001WMT

      Insert the multi-display assembly and attach the 8 claws on its backside.

      Note

      When inserting the multi-display assembly, do not press the knobs on it.

    3. Install the 2 bolts and 2 screws.

      Torque:
      for Bolt
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

  6. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  7. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  8. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Navigation System)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.