HEADLIGHT LEVELING ECU(for LHD) REMOVAL

Click here

PROCEDURE

1. Click here

   PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing (Click here).

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work (Click here).

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

3. Click here

   REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

   Click here

4. Click here

   REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

   Click here

5. Click here

   REMOVE INSTRUMENT SIDE PANEL RH

   Click here

6. Click here

   REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

7. Click here

   REMOVE FRONT DOOR SCUFF PLATE RH

   Click here

8. Click here

   REMOVE COWL SIDE TRIM BOARD RH

9. Click here

   REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

   Click here

10. Click here

    REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

11. Click here

    REMOVE INSTRUMENT PANEL BOX DOOR KNOB

    Click here

12. Click here

    REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

13. Click here

    REMOVE HEADLIGHT SWIVEL ECU ASSEMBLY

    
    
    1. 

       Disconnect the connector.

    2. Remove the nut and headlight swivel ECU assembly.