REAR COMBINATION LIGHT ASSEMBLY(for Double Swing Out Type) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH


    1. Attach the claw.

    2. Attach the 2 guide to install the rear combination light socket and wire sub-assembly LH.

  2. INSTALL TAIL AND STOP LIGHT BULB


    1. A01X0HZ

      Install the tail and stop light bulb to the rear combination light socket and wire sub-assembly LH.

    2. Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration to install the socket.

  3. INSTALL REAR TURN SIGNAL LIGHT BULB


    1. A01X63M

      Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly LH.

    2. Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration to install the socket.

  4. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH


    1. A01X386E01
      Text in Illustration
      *1 Protective tape

      Connect the connector.

    2. Attach the 3 clips, 2 guides and 2 claws to install the rear combination light assembly LH.

      Note

      Attach the bolt installation bracket form outside the body while being careful not to bend it.

    3. Install the 2 bolts.