REAR COMBINATION LIGHT ASSEMBLY(for Double Swing Out Type) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH


    1. A01X4PUE01
      Text in Illustration
      *1 Protective tape

      Put protective tape around the rear combination light assembly LH.

    2. Remove the 2 bolts.

    3. Detach the 3 clips, 2 guides and 2 claws.

      Note

      Detach the bolt installation bracket from inside the body while being careful not to bend it.

    4. Disconnect the connector to remove the rear combination light assembly.

  2. REMOVE REAR TURN SIGNAL LIGHT BULB


    1. A01X1ER

      Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration and remove the socket.

    2. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly LH.

  3. REMOVE TAIL AND STOP LIGHT BULB


    1. A01X8BA

      Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration and remove the socket.

    2. Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly LH.

  4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH


    1. A01X3D2

      Using a screwdriver, detach the claw.

    2. Detach the 2 guide and remove the rear combination light socket and wire sub-assembly LH.