HIGH INTENSITY DISCHARGE HEADLIGHT BULB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL DISCHARGE HEADLIGHT BULB


    1. A01XA4Y

      Install the discharge headlight bulb and lock the set spring as shown in the illustration.

      Note

      Do not touch the discharge headlight bulb glass.

  2. INSTALL HEADLIGHT GASKET


    1. Install a new headlight gasket to the headlight light control ECU sub-assembly LH.

  3. INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH


    1. A01X9U6

      Turn the headlight light control ECU sub-assembly LH socket in the direction indicated by the arrow in the illustration to connect the headlight light control ECU sub-assembly LH socket.

      Note


      • Check that the headlight gasket is installed on the headlight light control ECU subassembly LH.

      • Check that the headlight gasket is not damaged or contaminated with foreign matter. If there is any damage, replace the headlight gasket with a new one.

      • Do not pull the headlight light control ECU sub-assembly LH with the socket connected.

    2. A01X3YC

      Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow in the illustration to install the headlight unit.

    3. Connect the connector.

  4. INSTALL BATTERY


    1. Install the battery.

    2. Install the stay and bolt.

    3. Connect cable to positive battery terminal.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.