| DTC Code | DTC Name |
|---|---|
| B2417 | Headlight Beam Level Control Motor LH Malfunction |
| B2418 | Headlight Beam Level Control Motor RH Malfunction |
DESCRIPTION
The headlight leveling motor receives a signal from the headlight swivel ECU to operate. The headlight swivel ECU receives a signal indicating the operating conditions of the headlight leveling motor.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2417 |
|
|
| B2418 |
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Note
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
After replacing the headlight swivel ECU, initialization of the ECU is necessary (except w/ Dynamic Headlight Auto Leveling) Click here.
PROCEDURE
CHECK FOR DTC
Clear the DTCs Click here.
Check for DTCs Click here.
| OK |
|---|
| DTC B2417 or B2418 output does not occur. |
| OK |
|
USE SIMULATION METHOD TO CHECK Click here |
| NG |
|
PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HEADLIGHT LEVELING MOTOR)
Using the intelligent tester, perform the Active Test Click here.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive The Leveling Motor UP* | Headlight leveling motor upward operation | ON/OFF | ON: Move up OFF: Stop |
| Drive The Leveling Motor DOWN* | Headlight leveling motor downward operation | ON/OFF | ON: Move down OFF: Stop |
*: Perform the Active Test with the engine running and vehicle stopped.
| OK |
|---|
| Headlight leveling motors operate normally. |
| NG |
|
CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL ECU ASSEMBLY - BATTERY AND BODY GROUND) Click here |
| OK |
|
CHECK HEADLIGHT LEVELING MOTOR
Temporarily replace the headlight leveling motor with a new or normally functioning one Click here.
Check for DTCs Click here.
| OK |
|---|
| DTC B2417 or B2418 output does not occur. |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
| A |
|
END (HEADLIGHT LEVELING MOTOR WAS DEFECTIVE) |
| B |
|
REPLACE HEADLIGHT SWIVEL ECU ASSEMBLY Click here |
| C |
|
REPLACE HEADLIGHT SWIVEL ECU ASSEMBLY Click here |
CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL ECU ASSEMBLY - BATTERY AND BODY GROUND)
| *a | Front view of wire harness connector (to Headlight Swivel ECU Assembly) |
Disconnect the headlight swivel ECU connector.
Measure the voltage according to the value(s) in the table below.
| Standard Voltage | ||||||
|---|---|---|---|---|---|---|
|
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL ECU ASSEMBLY - HEADLIGHT UNIT ASSEMBLY)
Disconnect the E101 headlight swivel ECU connector.
Disconnect the A54*1 or A58*2 headlight unit connector.
*1: for LH
*2: for RH
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| for LH | |||||||||||||||||||||
|
|||||||||||||||||||||
| for RH | |||||||||||||||||||||
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
INSPECT HEADLIGHT UNIT ASSEMBLY
Remove the headlight unit Click here.
| *a | Component without harness connected (Headlight Unit Assembly LH) |
*b | Component without harness connected (Headlight Unit Assembly RH) |
| *c | Front view of wire harness connector (to Headlight Leveling Motor LH) |
*d | Front view of wire harness connector (to Headlight Leveling Motor RH) |
Disconnect the headlight leveling motor connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||||
|---|---|---|---|---|---|---|---|---|
| for LH | ||||||||
|
||||||||
| for RH | ||||||||
|
| NG |
|
REPLACE HEADLIGHT UNIT ASSEMBLY Click here |
| OK |
|
CHECK HEADLIGHT LEVELING MOTOR
Temporarily replace the headlight leveling motor with a new or normally functioning one Click here.
Check for DTCs Click here.
| OK |
|---|
| DTC B2417 or B2418 output does not occur. |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
| A |
|
END (HEADLIGHT LEVELING MOTOR WAS DEFECTIVE) |
| B |
|
REPLACE HEADLIGHT SWIVEL ECU ASSEMBLY Click here |
| C |
|
REPLACE HEADLIGHT SWIVEL ECU ASSEMBLY Click here |