LIGHTING SYSTEM Hazard Warning Switch Circuit

DESCRIPTION

The turn signal flasher receives a hazard warning signal switch information signal, and illuminates the turn signal lights.

WIRING DIAGRAM

A01X4KXE02

PROCEDURE


  1. CHECK VEHICLE TYPE


    1. Check the vehicle type.

      Result
      Result Proceed to
      w/o Multi-display A
      w/ Multi-display B

    B

    INSPECT MULTI-DISPLAY (HAZARD WARNING SIGNAL SWITCH) Click here

    A

  2. INSPECT HAZARD WARNING SIGNAL SWITCH


    1. Remove the hazard warning signal switch Click here.

    2. Inspect the hazard warning signal switch Click here.


    NG

    REPLACE HAZARD WARNING SIGNAL SWITCH Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH - TURN SIGNAL FLASHER ASSEMBLY AND BODY GROUND)


    1. Disconnect the F11 hazard warning signal switch connector.

    2. Disconnect the E19 turn signal flasher connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F11-4 (F) - E19-8 (HAZ) Always Below 1 Ω
      F11-1 (E) - Body ground
      F11-4 (F) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  4. INSPECT MULTI-DISPLAY (HAZARD WARNING SIGNAL SWITCH)


    1. A01X4D0E01

      Remove the multi-display Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      21 (HAZ) - Body ground (Multi-display body ground) Hazard warning switch on Below 1 Ω
      Hazard warning switch off 10 kΩ or higher

    NG

    REPLACE MULTI-DISPLAY (HAZARD WARNING SIGNAL SWITCH) Click here

    OK

  5. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY [HAZARD WARNING SIGNAL SWITCH] - TURN SIGNAL FLASHER ASSEMBLY AND BODY GROUND)


    1. Disconnect the F79 multi-display connector.

    2. Disconnect the E19 turn signal flasher connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F79-21 (HAZ) - E19-8 (HAZ) Always Below 1 Ω
      F79-13 (GND1) - Body ground
      F79-21 (HAZ) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR