RAIN SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL RAIN SENSOR TAPE

    Tech Tips

    Rain sensor tape is reusable. Only replace the rain sensor tape if it is damaged or contaminated.


    1. Clean the sensing portion of the rain sensor with a piece of cloth, etc.

    2. A01WZFHE01
      Text in Illustration
      *1 Rain Sensor Tape

      Peel off the smaller release sheet, and then attach the rain sensor tape to the sensing portion of the rain sensor as shown in the illustration.

      Standard Clearance
      Area Measurement
      A 13.5 mm (0.532 in.)
      B 7.25 mm (0.285 in.)

      Note

      Use your fingers to push out any air bubbles from under the rain sensor tape.

  2. INSTALL RAIN SENSOR


    1. Clean the windshield glass with a piece of cloth, etc.

      Note


      • Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

      • If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.

    2. When installing a new rain sensor or replacing the rain sensor tape:.


      1. Peel off the release sheet.

        Tech Tips

        Do not touch the silicon coated surfaces.

    3. A01X7JOE01
      Text in Illustration
      *a Stopper
      *b Guide
      B001XPG Lock
      A01X4WG Install

      Attach the 2 guides, and then carefully install the rain sensor to the glass surface so that air bubbles do not form between the contact surfaces.

      Note

      Do not touch the silicon coated or glass surfaces.

    4. Push in the stopper.

    5. A01X29G

      Connect the connector.

  3. INSTALL RAIN SENSOR COVER


    1. A01X0HS

      Attach the 2 claws to install the rain sensor cover.

    2. A01X6XC

      Slide the rain sensor cover to attach the 2 guides.