WIPER ECU REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

    Click here

  4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

  5. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  6. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

    Click here

  8. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  9. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  10. REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  11. REMOVE INSTRUMENT PANEL BOX DOOR KNOB

    Click here

  12. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  13. REMOVE WINDSHIELD WIPER RELAY ASSEMBLY


    1. B001VQ4

      Disconnect the connector.

    2. Remove the screw.

    3. Detach the 2 guides and remove the windshield wiper relay assembly