WIPER ECU REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)

    Click here

  4. REMOVE INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

    Click here

  6. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  7. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

    Click here

  8. REMOVE LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

    Click here

  9. REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  10. REMOVE INSTRUMENT PANEL BOX DOOR KNOB

    Click here

  11. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  12. REMOVE WINDSHIELD WIPER ECU


    1. A01XAOQ

      Disconnect the 2 connectors.

    2. Remove the bolt and windshield wiper ECU.