WASHER NOZZLE(for Front Side) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. INSPECT WASHER NOZZLE SUB-ASSEMBLY


    1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

      Standard
      Washer fluid hits the windshield in the area shown in the illustration.

      If the result is not as specified, replace the washer nozzle.

      A01WZPSE04
      *1 Ceramic Standard Line
      Standard Measurement
      Area Specified Condition
      A 253.2 mm (9.97 in.)
      B 41.4 mm (1.63 in.)
      C 192.9 mm (7.59 in.)
      D 444.0 mm (17.48 in.)