FRONT WIPER MOTOR INSPECTION

PROCEDURE


  1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)


    1. A01X767E05

      Check the LO operation.


      1. Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 1 (+1)

        Battery negative (-) → Terminal 5 (E)

        Motor operates at low speed

        If the result is not as specified, replace the windshield wiper motor assembly.

    2. Check the HI operation.


      1. Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 4 (+2)

        Battery negative (-) → Terminal 5 (E)

        Motor operates at high speed

        If the result is not as specified, replace the windshield wiper motor assembly.

    3. Check the automatic stop operation.


      1. Connect the positive (+) battery lead to terminal 1 (+1) of the connector and the negative (-) battery lead to terminal 5 (E). With the motor operating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

      2. Using SST, connect terminals 3 (+S) and 1 (+1). Then connect the positive (+) battery lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

        SST
        09843-18040
      3. Check that the motor stops automatically at the automatic stop position.

        OK
        Automatically stops.

        If the result is not as specified, replace the windshield wiper motor assembly.

  2. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)


    1. A01X767E06

      Check the LO operation.


      1. Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 5 (+1)

        Battery negative (-) → Terminal 4 (E)

        Motor operates at low speed

        If the result is not as specified, replace the windshield wiper motor assembly.

    2. Check the HI operation.


      1. Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 3 (+2)

        Battery negative (-) → Terminal 4 (E)

        Motor operates at high speed

        If the result is not as specified, replace the windshield wiper motor assembly.

    3. Check the automatic stop operation.


      1. Connect the positive (+) battery lead to terminal 5 (+1) of the connector and the negative (-) battery lead to terminal 4 (E). With the motor operating at low speed (LO), disconnect terminal 5 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

      2. Using SST, connect terminals 1 (+S) and 5 (+1). Then connect the positive (+) battery lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

        SST
        09843-18040
      3. Check that the motor stops automatically at the automatic stop position.

        OK
        Automatically stops.

        If the result is not as specified, replace the windshield wiper motor assembly.