OUTER REAR VIEW MIRROR REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL SIDE TELEVISION CAMERA ASSEMBLY (w/ Side Monitor System)


    1. Install the side television camera with the 3 screws.

    2. Connect the connector.

    3. Install the body.


      1. Attach the 2 guides and body.

        Note

        Be careful not to break the guide.

    4. Install the body cover.


      1. Install the body with the 5 screws.

    5. A01X0UW

      Connect the connector.

    6. Attach the connector to the wire clip.

    7. Install the base


      1. Attach the guide.

      2. Using "TORX" socket wrench T25, install the base with 3 new screws.

        Note

        When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.

    8. Install the lower mirror cover.


      1. Attach the 4 claws and install a new lower mirror cover.

    9. Install the gasket.


      1. Attach the 9 guides and install the gasket.

      2. A01WZYBE02
        Text in Illustration
        *1 New Vinyl Tape
        *a Marking

        Align the marking on the wire harness with the marking on the end of the wire harness insertion hole of the gasket as shown in the illustration, and wrap them with new vinyl tape starting from the gasket marking.

        Standard
        Area Specified Condition
        a 50.0 mm (1.97 in.)

        Note

        If the vinyl tape is wrinkled, water may run down the wire harness and enter the vehicle. Make sure to wind the vinyl tape properly.

      3. A01XAGBE01
        Text in Illustration
        *1 New Vinyl Tape

        Wrap new vinyl tape as shown in the illustration.

        Standard
        Area Specified Condition
        a 30.0 mm (1.18 in.)
        b 50.0 mm (1.97 in.)

  2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH

    Click here

  3. INSTALL OUTER MIRROR COVER


    1. Install the outer mirror cover.


      1. A01XAIOE01
        Text in Illustration
        *1 Rib

        Insert the rib on the outer edge of the cover into the groove of the mirror body.

        Note

        Do not scratch the turn light.

      2. A01WZSY

        While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.

    2. A01X2HG

      Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.

    3. Check that there is no gap between the cover and mirror body.

      Tech Tips

      If there is a gap between the cover and body, noise will occur during driving.

  4. INSTALL OUTER MIRROR LH

    Click here