Click here

OUTER REAR VIEW MIRROR REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  4. Click here

    REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

    Click here

  5. Click here

    REMOVE FRONT UPPER ARMREST BASE PANEL LH

    Click here

  6. Click here

    REMOVE DOOR ASSIST GRIP COVER LH

    Click here

  7. Click here

    REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  8. Click here

    REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH

    Click here

  9. Click here

    REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


    1. w/ Power Mirror Control System:


      1. Disconnect the connector labeled A.

      2. Detach the clamp.

    2. Remove the 3 nuts and claw.

    3. Remove the outer rear view mirror.