FUEL LID LOCK CONTROL CABLE ASSEMBLY(for RHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  4. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  5. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  6. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  7. REMOVE REAR STEP COVER

    Click here

  8. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  9. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  10. REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

    Click here

  11. REMOVE REAR NO. 1 SEAT COVER BEZEL (w/ Rear No. 2 Seat)

    Click here

  12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

    Click here

  13. REMOVE FUEL FILLER OPENING LID LOCK RETAINER

    B001X88

    1. Turn the cable counterclockwise and remove the cable from the retainer.

    2. B001YES

      Turn the lock retainer counterclockwise and remove the lock retainer.

  14. REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY


    1. B001ZRC

      Detach the 2 claws.

    2. Disconnect the fuel lid lock control cable and remove the fuel lid lock open lever.

  15. REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY


    1. Using a screwdriver, disconnect the clamps shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

      B001VVT

    2. Remove the lock control cable.