POWER BACK DOOR DRIVE UNIT INSTALLATION

PROCEDURE

1. INSTALL POWER BACK DOOR UNIT ASSEMBLY

   
   

   1. Attach the 2 claws to install the power back door unit assembly.

   2. Install the 4 bolts.

      Torque:

      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

   3. Connect the connector.

2. INSTALL REAR UPPER PILLAR GARNISH RH

   Click here

3. INSTALL BACK DOOR SERVICE HOLE COVER RH

   Click here

4. INSTALL BACK DOOR SIDE GARNISH RH

   Click here

5. INSTALL CENTER BACK DOOR GARNISH

   Click here

6. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH

   Click here

7. INSTALL REAR SEAT COVER CAP RH (w/ Rear No. 2 Seat)

   Click here

8. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

   Click here

9. INSTALL REAR DOOR SCUFF PLATE RH

   Click here

10. INSTALL REAR STEP COVER

    Click here

11. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)

    Click here

    Tech Tips

    Use the same procedure described for the LH side.

12. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.