POWER BACK DOOR DRIVE UNIT REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

   Click here

4. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)

   Click here

   Tech Tips

   Use the same procedure described for the LH side.

5. REMOVE REAR STEP COVER

   Click here

6. REMOVE REAR DOOR SCUFF PLATE RH

   Click here

7. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

   Click here

8. REMOVE REAR SEAT COVER CAP RH (w/ Rear No. 2 Seat)

   Click here

9. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

   Click here

10. REMOVE CENTER BACK DOOR GARNISH

    Click here

11. REMOVE BACK DOOR SIDE GARNISH RH

    Click here

12. REMOVE BACK DOOR SERVICE HOLE COVER RH

    Click here

13. REMOVE REAR UPPER PILLAR GARNISH RH

    Click here

14. REMOVE POWER BACK DOOR UNIT ASSEMBLY

    
    

    1. 

       Disconnect the connector

    2. Remove the 4 bolts.

    3. Detach the 2 claws and remove the power back door unit assembly.