HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. REMOVE FRONT FENDER MAIN SEAL LH (for LHD)


    1. A01X4YG

      Using a screwdriver, detach the 3 clips and remove the fender main seal.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE FRONT FENDER MAIN SEAL RH (for RHD)


    1. A01X0ZW

      Using a screwdriver, detach the 3 clips and remove the fender main seal.

      Tech Tips

      Tape the screwdriver tip before use.

  4. REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY (w/ Winch)

    Click here

  5. REMOVE RADIATOR GRILLE ASSEMBLY

    Click here

  6. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  7. REMOVE HOOD LOCK CONTROL CABLE COVER


    1. A01X88GE03
      *1 for LHD:
      *2 for RHD:

      Remove the 3 screws.

    2. Detach the claw and remove the cable cover.

  8. REMOVE HOOD LOCK NUT CAP


    1. A01X814E02
      *1 for LHD:
      *2 for RHD:

      Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

  9. REMOVE HOOD LOCK ASSEMBLY


    1. A01X0HYE03
      *1 for LHD:
      *2 for RHD:

      Remove the 2 bolts and nut.

    2. Remove the hood lock.

    3. Disconnect the connector.

    4. A01X404E03
      *1 for LHD:
      *2 for RHD:

      Disconnect the hood lock control cable.

  10. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01X137

      Detach the 2 claws.

    2. Disconnect the hood lock control cable and remove the hood lock lever.

  11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

    A01XA2W

    1. Using a screwdriver, disconnect the clamps shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Pull the cable from the engine room and remove it.

  12. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

    A01X17J

    1. Using a screwdriver, disconnect the clamps shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Pull the cable from the engine room and remove it.