POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. Apply MP grease to the sliding and rotating areas of the regulator motor.

    2. Using a T25 "TORX" driver, install the motor with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new rear window regulator motor uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

    Click here

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  4. INSTALL REAR DOOR QUARTER WINDOW GLASS

    Click here

  5. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  6. INSTALL REAR DOOR GLASS RUN

    Click here

  7. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  8. INSTALL REAR SPEAKER SET (w/ Rear Speaker)

    Click here

  9. INSTALL REAR INNER DOOR GLASS WEATHERSTRIP

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  11. INSTALL ASSIST GRIP COVER

    Click here

  12. INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY

    Click here

  13. INSTALL REAR DOOR INSIDE HANDLE BEZEL

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.