POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR DOOR INSIDE HANDLE BEZEL

    Click here

  4. REMOVE REAR DOOR UPPER ARMREST BASE PANEL

    Click here

  5. REMOVE ASSIST GRIP COVER

    Click here

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP

    Click here

  8. REMOVE REAR SPEAKER SET (w/ Rear Speaker)

    Click here

  9. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  10. REMOVE REAR DOOR GLASS RUN

    Click here

  11. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  12. REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

  13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  14. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

    Click here

  15. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. B001ZBNE01
      Text in Illustration
      *a for Models with Jam Protection Function on 4 Windows
      *b for Models with Jam Protection Function on Driver Door Window Only

      Using a T25 "TORX" driver, remove the 3 screws and motor.

      Note

      Be careful when removing the screws as the motor may fall and become damaged.