Click here

POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart (Click here).

Click here

PROCEDURE


  1. Click here

    INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. Apply MP grease to the sliding and rotating areas of the regulator motor.

    2. Using a T25 ''TORX'' driver, install the motor with the 3 screws.

      5.4 N*m 55 kgf*cm 48 in.*lbf
      Tip:

      A new front window regulator motor uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. Click here

    INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

    Click here

  3. Click here

    INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  4. Click here

    INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  5. Click here

    INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

    Click here

  6. Click here

    INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  7. Click here

    INSTALL DOOR ASSIST GRIP COVER

    Click here

  8. Click here

    INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY

    Click here

  9. Click here

    INSTALL FRONT DOOR INSIDE HANDLE BEZEL

    Click here

  10. Click here

    INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH

    Click here

  11. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).