FRONT CONSOLE BOX(w/ Cool Box) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL COOLING BOX ASSEMBLY

    A01XB90

    1. Attach the 2 claws.

    2. Connect the connector.

    3. Sufficiently apply compressor oil to 2 new O-rings.

      Compressor oil
      ND-OIL 8 or equivalent

    4. Install the 2 O-rings on the 2 cooler pipes.

    5. Connect the 2 cooler pipes with the 2 bolts.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    6. Install the cooling box with the 4 bolts and 2 screws.

  2. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY


    1. A01XAZX

      Connect the connectors and 2 clamps.

    2. Attach the 8 claws to install the end panel.

  3. INSTALL NO. 1 COOLER COVER


    1. A01X92O

      Attach the claw on the upper part of the cooler cover, and then attach the clamp on the lower part of the cooler cover to install it.

  4. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A01XAGK

      Connect the connectors.

    2. Attach the 14 claws to install the console panel.

  5. INSTALL CONSOLE CUP HOLDER BOX SUB-ASSEMBLY


    1. A01XAY8

      Attach the 4 claws to install the box.

  6. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A01X0M8

      Attach the 9 claws to install the panel.

  7. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01XBUZ

      Connect the connectors.

    2. Attach the 7 claws to install the panel.

  8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. Install the shift lever knob and twist it in the direction indicated by the arrow.

      A01X8AHE01
      *1 for Automatic Transmission:
      *2 for Manual Transmission:

  9. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH


    1. A01X1XU

      Attach the 7 claws to install the panel pad.

    2. Install the screw.

    3. Install the clip.

  10. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION


    1. A01X17Q

      Attach the 7 claws to install the panel cushion.

  11. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH


    1. A01X92E

      Connect the connectors and 2 clamps.

    2. Attach the 8 claws to install the panel pad.

    3. Install the screw.

    4. Install the clip.

  12. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION


    1. A01XAVQ

      Attach the 7 claws to install the panel cushion.

  13. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat)


    1. Install the front seat assembly LH Click here.

  14. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat)


    1. Install the front seat assembly LH Click here.

  15. CHARGE REFRIGERANT

    Click here

  16. WARM UP ENGINE

    Click here

  17. CHECK FOR REFRIGERANT GAS LEAK

    Click here