VOLTAGE INVERTER ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT VOLTAGE INVERTER

    Tech Tips

    Remove interior parts so that the voltage inverter can be seen.


    1. A01X50SE01
      Text in Illustration
      *a

      Front view of wire harness connector:

      (to Voltage Inverter)

      Disconnect the voltage inverter connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      K44-5 (IG) - K44-1 (GND) Ignition switch on (IG) 10 to 16 V
      K44-1 (GND) - Body ground Always Below 1 V

      If the result is not as specified, repair or replace the harness or connector.

    3. A01X81XE01
      Text in Illustration
      *a

      Component with harness connected:

      (Voltage Inverter)

      Reconnect the voltage inverter connector.

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      K44-4 (AC1) - K44-8 (AC2)

      Ignition switch on (IG)

      Main switch on

      		 AC 198 to 242 V

      If the result is not as specified, replace the voltage inverter.