RELAY(w/ Viscous Heater) ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE VISCOUS HEATER RELAY

    A01X1G3

    1. Remove the viscous heater relay from the engine room relay block.

  2. INSPECT VISCOUS HEATER RELAY

    A01XBUTE97

    1. Measure the resistance of the viscous heater relay.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminal 1 and 2 Below 1 Ω

      • If the result is not as specified, replace the relay.

  3. INSTALL VISCOUS HEATER RELAY

    A01X1G3

    1. Install the viscous heater relay to the engine room relay block.