DUCT TEMPERATURE SENSOR(w/ Heater) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR NO. 1 SEAT ASSEMBLY LH


    1. for 60/40 Split Seat Type 40 Side:

      Click here

    2. for 60/40 Split Seat Type 60 Side:

      Click here

  4. REMOVE REAR NO. 1 SEAT ASSEMBLY RH


    1. for 60/40 Split Seat Type 40 Side:

      Click here

    2. for 60/40 Split Seat Type 60 Side:

      Click here

  5. REMOVE REAR NO. 2 SEAT ASSEMBLY LH


    1. for Face to Face Seat Type:

      Click here

    2. except Face to Face Seat Type:

      Click here

  6. REMOVE REAR NO. 2 SEAT ASSEMBLY RH


    1. for Face to Face Seat Type:

      Click here

    2. except Face to Face Seat Type:

      Click here

  7. REMOVE REAR DOOR SCUFF PLATE LH


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  8. REMOVE REAR DOOR SCUFF PLATE RH


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  9. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  10. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  11. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat)


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  13. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat)


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  14. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  15. REMOVE REAR NO. 1 SEAT PROTECTOR

    Click here

  16. REMOVE REAR NO. 2 SEAT PROTECTOR

    Click here

  17. REMOVE FRONT FLOOR CARPET ASSEMBLY

    B001YPV

    1. Fold back the floor carpet.

      Tech Tips

      Fold back the carpet until it is possible to remove the rear No. 6 air duct.

  18. REMOVE REAR NO. 6 AIR DUCT


    1. Disconnect the 2 connectors.

    2. Remove the 5 screws and duct.

      B001Z0G

  19. REMOVE DUCT TEMPERATURE SENSOR


    1. Detach the 4 claws and remove the 2 sensors.

      B001WGX