REAR AIR CONDITIONING UNIT(w/o Heater) INSTALLATION

PROCEDURE

1. INSTALL REAR COOLING UNIT ASSEMBLY

   
   

   1. Install the rear cooling unit as shown in the illustration.

      
   2. 

      Install the 4 bolts.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

   3. Connect the connector.

2. INSTALL REAR ROOF NO. 1 AIR DUCT

   

   
   

   1. Install the duct with the clip.

   2. 

      Attach the 2 claws to install the cooler plate.

3. CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

   

   
   

   1. Remove the attached vinyl tape from the pipe.

   2. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the air conditioner tube and accessory assembly.

   3. Install the 2 O-rings to the air conditioner tube and accessory assembly.

   4. Connect the air conditioner tube and accessory assembly.

   5. Install the 2 bolts.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

4. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

   
   

   1. w/ Sliding Roof:

      Click here

   2. w/o Sliding Roof:

      Click here

5. INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat)

   
   

   1. w/ Sliding Roof:

      Click here

   2. w/o Sliding Roof:

      Click here

6. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

   Click here

7. INSTALL REAR DOOR SCUFF PLATE LH

   
   

   1. w/ Sliding Roof:

      Click here

   2. w/o Sliding Roof:

      Click here

8. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

   
   

   1. w/ Sliding Roof:

      Click here

   2. w/o Sliding Roof:

      Click here

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

10. CHARGE REFRIGERANT

    Click here

11. WARM UP ENGINE

    Click here

12. CHECK FOR REFRIGERANT GAS LEAK

    Click here

13. CHECK SRS WARNING LIGHT

    Click here

14. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here