Click here

REAR AIR CONDITIONING UNIT(w/o Heater) REASSEMBLY

Click here
Click here

PROCEDURE


  1. Click here

    INSTALL WIRING AIR CONDITIONING HARNESS SUB-ASSEMBLY

  2. Click here

    INSTALL EVAPORATOR SUB-ASSEMBLY


    1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

      Compressor oil
      ND-OIL 8 or equivalent

    2. Install the 2 O-rings to the evaporator.

    3. Install the evaporator.

    4. B001VOQ

      Install the rear cooling unit case LH with the 12 screws.

  3. Click here

    INSTALL REAR BLOWER MOTOR


    1. Install the blower motor with the 3 screws.

    2. Connect the connector.

  4. Click here

    INSTALL BLOWER RESISTOR


    1. Install the blower resistor with the 2 screws.

    2. Connect the connector.

  5. Click here

    INSTALL REAR COOLING UNIT EXPANSION VALVE


    1. Using a 4 mm hexagon wrench, install the expansion valve with the 2 hexagon bolts.

      3.5 N*m 36 kgf*cm 31 in.*lbf

    2. Attach the clamp.

    3. Connect the connector.

  6. Click here

    INSTALL AIR CONDITIONER ACCESSORY ASSEMBLY


    1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

      Compressor oil
      ND-OIL 8 or equivalent

    2. Install the 2 O-rings to the air conditioner accessory assembly.

    3. Install the air conditioner accessory assembly.

    4. Install the bolt and 2 screws.

      5.4 N*m 55 kgf*cm 48 in.*lbf
    5. B001YM4

      Install new packing as shown in the illustration.

  7. Click here

    INSTALL DRAIN COOLER HOSE


    1. Attach the claw to install the drain hose.

    2. Install the screw.

  8. Click here

    INSTALL REAR SIDE NO. 3 AIR DUCT


    1. Install the duct with the 2 screws.

      5.4 N*m 55 kgf*cm 48 in.*lbf
  9. Click here

    INSTALL COOLING UNIT BRACKET


    1. Install the bracket with the 2 screws.

      5.4 N*m 55 kgf*cm 48 in.*lbf