REAR AIR CONDITIONING UNIT(w/o Heater) REMOVAL

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

    Click here

  3. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  6. REMOVE REAR DOOR SCUFF PLATE LH


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  7. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  8. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat)


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  9. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  10. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

    B001WN6

    1. Remove the 2 bolts.

    2. Disconnect the air conditioner tube and accessory assembly.

      Note


      • Do not use a screwdriver or similar tool to disconnect the tube.

      • Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

    3. Remove the 2 O-rings from the air conditioner tube and accessory assembly.

  11. REMOVE REAR ROOF NO. 1 AIR DUCT

    B001XK1

    1. Detach the 2 claws and remove the cooler plate.

    2. B001YV9

      Remove the clip and duct.

  12. REMOVE REAR COOLING UNIT ASSEMBLY

    B002043

    1. Disconnect the connector.

    2. Remove the 4 bolts and rear cooling unit.