FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    B001X07

    1. Align the adjuster positioning hole with the claw, and install the adjuster with the 2 bolts.

      Tech Tips

      First install the lower bolt, and then install the upper bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY

    B001VTHE01

    Note

    When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.


    1. Align the claws of the vehicle with the seat belt retractor positioning holes.

    2. Install the seat belt with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
    3. B001Y0BE01

      Connect the pretensioner connector labeled A as shown in the illustration.

    4. Connect the tension reducer connector labeled B.

    5. w/ Pre-Crash Safety System:

      Connect the pre-crash safety connector labeled C.

    6. B001YF1

      Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  3. INSTALL CENTER PILLAR GARNISH LH

    Click here

  4. INSTALL REAR ASSIST GRIP ASSEMBLY

    Click here

  5. INSTALL CENTER LOWER PILLAR GARNISH

    B001Z8X

    Tech Tips


    • for Manual Seat:

      When installing the center lower pillar garnish, move the front seat and seatback to the foremost upright position.

    • for Power Seat:

      When installing the center pillar garnish cover, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position.

      After moving the front seat, disconnect the cable from the negative (-) battery terminal.


    1. Attach the 2 claws and 7 clips to install the center lower pillar garnish.

    2. B001Y3K

      Install the seat belt anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  6. INSTALL CENTER PILLAR GARNISH COVER

    Click here

  7. INSTALL REAR DOOR SCUFF PLATE

    Click here

  8. INSTALL REAR STEP COVER

    Click here

  9. INSTALL FRONT DOOR SCUFF PLATE

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. CHECK SRS WARNING LIGHT

    Click here